User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 30
1.16 Mounting
The HX WCS unit is installed in the communication room via one of the following options (each type of installation
requires a different pair of brackets):
• Rack mount - rack ears preassembled
• Vertical wall mount (i.e. Belly-to-Wall; cabinet door faces side)
• (Optional) Horizontal - (i.e. Back-to-Wall; cabinet door faces front); separately ordered kit: AK-HX-ADDON-
B2W-MNT
1.16.1 General Instructions
• HX WCS remotes should be installed in a communication room that provides access only to authorized
personnel.
• The units are maintenance free. In the event of failure, only authorized personnel should handle the units.
• Only trained and qualified personnel should be allowed to install or replace this equipment.
• Verify that ambient temperature of the environment does not exceed 65°C (149°F)
1.16.2 Rack Mount Installation
1.16.2.1 Rack Installation General Safety Instructions
Review the following guidelines to help ensure your safety and protect the equipment from damage during the
installation.
• To maintain a low center of gravity, ensure that heavier equipment is installed near the bottom of the rack and
load the rack from the bottom to the top.
• Ensure that adequate airflow and ventilation within the rack and around the installed components so that the
safety of the equipment is not compromised.