User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 29
• HX Physical Installation
This chapter describes the mounting procedure and physical connections for the HX WCS Remote Unit.
1.15 Unpacking and Inspection
Unpack and inspect the cartons according to the following procedure
1. Open the shipping carton and carefully unpack each unit from the protective packing material.
2. Verify that all of the item required for installing the HX WCS have been received (refer to Table 3-1). If any
of the listed items are missing, contact your Corning representative.
3. Check for signs of external damage. If there is any damage, call your Corning service representative.
HX Kit Item Quantity
HX WCS Remote Unit:
• HX-WCS-SISO-NU*
• HX-WCS-SISO-PLUS*
• HX-WCS-MIMO**
*SISO models include one HX-WCS Module
and one slot cover (blank panel for
unoccupied HX-WCS Module
**MIMO slot) ; MIMO models include two
HX-WCS Modules
1
19-in rack brackets (factory assembled) –
(default mounting option) for rack-mount
installations
2
(RT/LT)
Flat Head Screw UNC 6-32, 8mm; Stainless
Steel
12
Wall Mount Bracket (Belly-to-Wall)
Assembly: Bracket
2
(RT/LT)
Pan Head Screw Sems UNC 6-32, 11 mm;
Stainless Steel; Used for securing bracket to
HX sides
20
Table 3-7. HX WCS Package Items List