User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 27
Coax
Length
Coax Loss
(900 MHz)
Connector
Loss
Total Loss
60 1.3 1.5 2.8
70 1.5 1.5 3
80 1.7 1.5 3.2
90 1.9 1.5 3.4
100 2.1 1.5 3.6
110 2.3 1.5 3.8
120 2.5 1.5 4
130 2.7 1.5 4.2
140 2.9 1.5 4.4
150 3.1 1.5 4.6
160 3.3 1.5 4.8
170 3.5 1.5 5
180 3.7 1.5 5.2
190 3.9 1.5 5.4
200 4.1 1.5 5.6
Table 2-6. Typical Coax Cable Lengths and Losses
1.10.4 Cable Routing
Ensure all cables, e.g. power cable, feeder cable, optic fiber, commissioning cable, connecting are properly
routed and secured so that they are not damaged.
1.11 Antenna Specifications and Guidelines
Determine the antenna installation configuration, according to the transmission and coverage requirements and
the installation site conditions.
1.11.1 Authorized Antennas and Couplers
• External antennas - No limitation on any vendor of available external antennas with respect to the following
requirements:
• Omni Directional or Directional
• Supported frequency range: wideband antennas supporting a range of 700 MHz to 2600 MHz
• Gain: up to 12.5 dBi
• Impedance: 50 Ohm
• Types of couplers/splitters – depends on number of splits
• Couplers – Use N-Male to N-Female broadband coupler separately ordered from Corning (P/N AK-
1COUPLER-NM-NF) or the equivalent: