User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 21
HX (MIMO) Internal Modules – PSU (Left) and HX WCS Modules (Middle and Right) Figure 1-7
Module Interface Description
PSU Power connector 34-48 V DC input; 6 pin DC terminal block connector
HX Module Optic Port (SC APC fiber-optic pair connector; SMF; connection
towards Base Unit (BU)
(SC APC fiber-optic pair connector; SMF; connection
towards additional remote unit
Extension UL/DL SMA type (future option)
Table 1-3. HX WCS Internal Module Connectors
Module LED Description
PSU Run Steady green – required power input detected
Off – no power input
PSU Off – normal operation
Steady red – faulty PSU module; In more than 10%
difference than the rated DC output, the red LED occurs.
HX-WCS
Module
BU Link Off – No optical link
Blinking green – Low optical link level
Steady green – Normal optical link level
Run Off – no power input