User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 19
Refer to Figure 1-6 and Table 1-2 for description of HX status LEDs.
HX WCS RCU Module Status LEDs Figure 1-6
Note: Module 1 and Module 2 LEDs correspond to installed modules [Module 1 for ANT. 1 (SISO); Module 2 for
ANT. 2 (MIMO)].
LED State Description
From HE
(from
headend)
Run Blinking green
Off
Power input detected
Unit powered off
Comm Green Short blink upon receiving FSK message
(Off at any other time)
Link Steady green Optical link level is above normal threshold
Blinking green Optical link level is lower than Normal threshold but
above no-link threshold
Off Optical link level is below No link threshold
Status Green / Yellow / Red Color according to device’s overall status
To Remote Comm Green Short blink upon receiving FSK message
(Off at any other time)
Link Steady green Optical link level is above normal threshold
Blinking green Optical link level is lower than Normal threshold but
above no-link threshold