User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 18
1.4.1 HX WCS External Interfaces
The HX WCS front panel includes the multiplexer interfaces (e.g. antenna port, DL Test port, wideband RU port),
system level status LEDs and service maintenance ports.
Note: Both SISO and MIMO models include two sets of multiplexer RF interfaces. For SISO models, the RF
connections will be performed via the connectors corresponding to the installed HX remote unit module (inside
chassis): Left MUX for Left HX WCS Module and Right MUX for Right HX WCS Module. (See section 1.4.2 for
internal modules.)
HX WCS Front Panel Interfaces Figure 1-5
Table 1-1 provides a description of the front panel connectors.
Connector Description
ANT 4.3-10 Type duplexed antenna port
WB-RU 4.3-10 Type duplexed wideband remote unit expansion port for interfacing to external RF In
source (i.e. HX4 remote) so that additional services are combined with those of the HX and
distributed from the duplexed HX antenna port
DL Test CPL.
Port
SMA-Type female 50Ω connector (40 dB ± 2 dB) used for RF DL test
RS-232 D-Type 9 pin female console port used for connecting to engineering GUI
RJ-45 Ethernet connection for local craft
Ext. 1 / Ext. 2 DB-9 female (Future option)
Ext. Alarms
DB-9 female external alarm connector for external dry contact alarm connections
GND Two-hole, standard barrel grounding lug
Table 1-1. HX Front Panel Connectors
Fan Modules
MUX
1
MUX 2
Opening for Routing
Power Cable
Opening for Routing
Fiber
Antenna
DL Test Coupling Port
RS-232 Console
Ethernet
RCU
Grounding Lug
Wideband RU (-0.5dB) Port
External Alarms Port