User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 14
1.1 Key Features and Capabilities
• Service Platform: Accommodates LTE and provides SISO/MIMO configuration for WCS band.
• Cost-Effective High Power: Optimizes and reduces the number of antennas required to cover open areas
by offering up to 33 dBm (2 W) composite power per frequency band.
• Scalability: Supports either SISO or MIMO service in a single compact enclosure.
• Operator-Grade Operation: Advanced signal handling and management ensures operator-grade
performance in multi-operator deployments.
• Design and Deployment Flexibility: Antenna splitting schemes are possible due to the higher power output
capability.
• Compatibility: Connects existing MobileAccess1000, MobileAccess2000 and MobileAccessHX remote units
to allow common antenna overlay; Shares a common headend and EMS in a single deployment.
• Monitoring and Web Management: All status LEDs are located on front panel; Web management via the
SC-450 controller (v7.2 and higher)