User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 45
2. Connect the four rear panel EPM low-band N-Type input ports to the corresponding SCU N-Type ANTENNA
PORTS”.
Note: The location of the SCU “ANTENNA PORTS” differ depending on model:
• SCU-4/SCU-8 units - antenna ports located on rear panel
• SCU-F/SCU-FT - antenna ports located on front panel
Example of Connections between EPM and MA2000 TSX
Figure 3-17
3. Connect the four EPM rear panel Mini DIN 4.3-10 “ANT” output ports to the wideband antennas.