User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 44
3.3.1.3 RF Connections to MA1000/MA2000 Remote
This section provides instructions on how to perform expansion connections between the HX 2.5GHz TDD unit and an
MA1000/MA2000 remote unit. The RF connections between the HX 2.5 GHz TDD unit and an MA1000/MA2000
remote require an EPM unit which interfaces between the HX 2.5 GHz TDD and the service combiner unit (SCU)
required for the MA1000/MA2000 remote.
IMPORTANT! Two EPM units are required for MIMO installations – each one connects to one HX 2.5 GHz TDD
“ANT.” port.
To connect expansion connections
1. Connect the HX 2.5 GHz TDD MUX “ANT” mini 4.3-10 Type duplexed RF port to the EPM front panel high
band mini DIN 4.3-10 input port, as shown in Figure
3-16.
Example of Connection between HX 2.5 GHz TDD and EPM
Figure 3-16