User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 41
RF Connections Between HX 2.5 GHz and Existing HX4 (Right-SISO; Left – MIMO)
Figure 3-12
2. Connect broadband antenna coax to the HX-2.5 GHz TDD MUX module “ANT” port (two for MIMO models) and
to broadband DAS antennas. Refer to Figure
3-13 for example.
ATTENTION! Terminate any unused RF ports with a 50 ohm termination load.
Example of HX 2.5 GHz TDD Antenna Connections (SISO)
Figure 3-13