User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 40
3.3 Connections
Note that the HX 2.5 GHz TDD is an upgrade unit and as such the RF and fiber connections also interface existing
HX4, HX WCS and MA1000/MA2000 remote units.
3.3.1 RF Connections
3.3.1.1 RF Connections to HX4 Remote
1. Perform the HX4 service connection as follows:
Connect From Port… To Port…
Unit: HX 2.5 GHz TDD Unit: HX4
Port Name: WB RU Port Name: (ANTENNA PORT) Port 1
Port Type: N-Type duplexed Port Type: N-Type duplexed
Table 3-3. HX4 Services Connection
Note: For SISO installations the connections are from HX 2.5 GHz TDD ANT 1 (MUX) “WB RU” port to the HX4
‘ANTENNA PORT 1”; For MIMO installations the MIMO 2 Stream connections are performed between the HX 2.5 GHz
TDD ANT 2 (MUX) “WB RU” port and the HX4 “‘ANTENNA PORT 2”.