User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 38
5. Insert two bolts in top anchors and tighten until bolt head is 0.5-in from surface of wall. See Figure 3-10.
Inserting First two Bolts in Anchors
Figure 3-10
6. Hang the unit and bracket assembly onto the two bolts using the key holes.
7. Insert remaining bolts (two on each side) through remaining bracket holes into anchor and tighten.
8. Verify that HX 2.5 GHz TDD unit is tightly secured and does not shake.
Refer to Figure
3-11 for HX 2.5 GHz TDD wall mount examples with additional MA2000 remote.