User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 37
To mount the HX 2.5GHz TDD unit on the wall:
1. Remove the factory assembled rack brackets from the sides of the HX 2.5 GHz TDD unit.
2. Using eight UNC 6-32, 12 mm screws for each bracket (provided in HX 2.5 GHz TDD kit), assemble the wall-
mount brackets to the rear of the HX 2.5 GHz TDD side panels.
3. Referring to Figure
3-9, prepare appropriate anchors and bolts for drilling.
Wall-Mount Bracket Dimensions
Figure 3-9
4. Using bracket holes as a template, mark holes for drilling in wall.