User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 29
3.2.2.2 Mounting HX 2.5 GHz TDD in 19-in Rack
Note the following:
• The HX 2.5 GHz TDD requires 4U rack height availability
• For installations with MA1000/MA2000 remote:
• EPM (1U) should be installed beneath the HX 2.5 GHz TDD unit in order to facilitate the connections
• 2U separation distance between the EPM and the top of the MA1000/MA2000 remote unit is required
• Rack nuts and screws not provided (depend on rack type)
To mount the HX 2.5 GHz TDD in a 19-in rack:
1. Determine the location of the HX 2.5 GHz TDD in the rack.
2. Secure the unit to the communication racks’ vertical uprights via at least two bracket holes on each side (one
top and one middle) using the appropriate rack nuts and screws.
Refer to Figure
3-1 and Figure 3-4 for examples of rack installations.
Examples of HX 2.5 GHz TDD Rack Installations with Additional HX4 and MA2000 QX Remotes
Figure 3-1