User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 27
3 Physical Installation
This chapter describes the mounting procedure and physical connections for the HX 2.5 GHz TDD remote unit.
3.1 Unpacking and Inspection
Unpack and inspect the cartons according to the following procedure
1. Open the shipping carton and carefully unpack each unit from the protective packing material.
2. Verify that all of the item required for installing the HX 2.5GHz TDD have been received (refer to Table
3-1). If
any of the listed items are missing, contact your Corning representative.
3. Check for signs of external damage. If there is any damage, call your Corning service representative.
HX Kit Item Quantity
HX 2.5 GHz TDD remote unit:
• HX-2500-SISO*
HX-2500-MIMO**
*SISO models include one HX-2.5 GHz TDD
Module (internal) and one slot cover (blank panel
for unoccupied HX-2.5 GHz TDD Module MIMO
slot)
** MIMO models include two HX-2.5 GHz TDD
Modules
1
19-in rack brackets (factory assembled) – (default
mounting option) for rack-mount installations
2
(RT/LT)
Flat Head Screw UNC 6-32, 8mm; Stainless
Steel
12
Wall Mount Bracket (Belly-to-Wall) Assembly:
Bracket
2
(RT/LT)
Pan Head Screw Sems UNC 6-32, 12 mm;
Stainless Steel; Used for securing bracket to HX
sides
20
Table 3-1. HX 2.5 GHz TDD Package Items List