User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Introduction
CMA-xxx-AEN
Page 19
1.4.2 Internal Module Interfaces
The HX internal modules include two main modules (see Figure 1-8):
• PSU – Power supply module; includes DC In connector and status LEDs
• HX Module – one for SISO cabinets and two for MIMO (the interfaces are the same for each module); comprises
an optical module and power amplifier; interfaces to the base unit; Left HX Module 2 (MIMO) corresponds to left
HX MUX and right HX Module 1 (SISO) corresponds to right MUX.
HX (MIMO) Internal Modules – PSU (Left) and HX 2.5 GHz TDD Modules (Middle and Right)
Figure 1-8
Module Interface Description
PSU Power connector 34-48 V DC input; 8 pin DC terminal block connector
(Dinkle 2EHDRM-08P)
HX Module Optic Port SC APC fiber-optic pair connector; SM fiber; connection
towards OCH
Extension UL/DL SMA Type connector N/A (future option)
Table 1-3. HX 2.5 GHz TDD PSU and Module Connectors