User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Introduction
CMA-xxx-AEN
Page 15
1.3 System Monitoring and Management
The HX 2.5 GHz TDD remote unit is centrally managed via the SC-450 controller (v7.3 and higher). Note that HX is
not directly connected to the controller but managed and configured via the OCH to which it is connected. Figure
1-4
shows the main configuration window for the selected HX 2.5 GHz TDD unit.
Note: Refer to the SC-450 controller user manual (v7.3 and higher) for information on how to configure and manage
the HX 2.5 GHz TDD remote unit.
Example of HX 2.5GHz TDD Configuration Tab
Figure 1-4