User's Manual
Table Of Contents
- Preface Material
- Policy for Warrantee and Repair
- Safety Instructions
- Warnings and Admonishments
- Standards and Certification
- About this Guide and Other Relevant Documentation
- Table of Contents
- 1 Introduction to GX System
- 2 System Installation
- 3 Commissioning MA Head-End
- 4 Provisioning the MobileAccessGX
- Appendix A: System Specifications
- Appendix B: Ordering Information
- Appendix C: Site Preparation
MobileAccessGX Installation and Configuration Guide 13
Figure 2-3. GX Mounting Brackets
3. Using two (M10x110) Masonry bolts per bracket – secure the Mounting Brackets to the wall
with the protruding M8 nuts
facing towards you. The GX will be hung on these.
Figure 2-4. Illustration of Bracket Mounted on Wall – Top View
4. Connectors facing down, carefully fit and hang the GX unit on to the (three) protrusions of
the upper and lower mounting brackets.
5. Firmly pull the GX downwards to securely hang on the protrusions.
6. Tighten protrusion nuts using spanner.
15cm
123.9cm
Masonry bolts