User's Manual
Table Of Contents
- Preface Material
- Policy for Warrantee and Repair
- Safety Instructions
- Warnings and Admonishments
- Standards and Certification
- About this Guide and Other Relevant Documentation
- Table of Contents
- 1 Introduction to GX System
- 2 System Installation
- 3 Commissioning MA Head-End
- 4 Provisioning the MobileAccessGX
- Appendix A: System Specifications
- Appendix B: Ordering Information
- Appendix C: Site Preparation
MobileAccessGX Installation and Configuration Guide 10
2.4 Assembling Radome on GX – TBD
Radome (optional) must be assembled before the unit is mounted.
2.5 Assembling External Filter (If Required)
An external filter is required in installations where the GX remote unit is deployed with units
supporting the 800MHz band.
NOTE 1: The External Filter is not supplied with the GX unit and must be ordered separately.
NOTE 2: If possible, it is recommended to perform this procedure before the GX unit is mounted.
Figure 2-1. External Combiner
Mount the External Filter on the GX remote unit and connect as shown in Figure 2-2.
Figure 2-2. GX with Mounted External Filter
External Filter
GX Remote Unit