User's Manual
Table Of Contents
- 1 1Introduction
- 2 2Installation Guidelines
- 3 3System Installation
- 3.1 Selecting GX Dual-Band Mounting Location
- 3.2 Unpacking and Inspection
- 3.3 Additional Required Tools
- 3.4 Required Headend Connections for Deployments with Corning® Optical Network Evolution (ONE™) Solution
- 3.5 Outdoor Concrete Wall-Mountable Installation
- 3.6 Additional Installation Options
- 3.7 GX Connections
- 3.8 Verifying Normal Operation
- 4 4Appendices
Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 35
4
4
APPENDICES
4.1 Appendix A: System Specifications
RF Parameters
Supported services
Technologies
Frequency Range
Service/Band Uplink Downlink
LTE WCS 2305-2315 2350-2360
LTE TDD 2.5 GHz 2496-2690 2496-2690
Supported Services | Table 4.1
RF Parameters per Service (40 W)
Notice: The manufacturer’s rated output power of this equipment is for the composite band or a single carrier operation. For situations when
multiple carrier signals are present, the rating for each carrier would have to be reduced by 10*Log(N), where N is the number of the
transmitted channels. The gain reduction for each carrier shall be done on the headend, and not by an attenuator at the output of the device.
LTE WCS LTE 2.5 GHz TDD
RF Parameters DL UL DL UL
Nominal Bandwidth (MHz) 10 10 60 MHz
Between 2496
to 2690
60 MHz
Between 2496 to
2690
Mean Output Power (dBm) 46 46
Maximum Output Power (dBm)
1 Carrier (Composite)
46 46
2 Carriers 43 43
4 Carriers 40 40
Nominal Passband Gain (dB) 66 (OCH to GX) 50 (GX to OCH) 66 (OCH to GX) 50 (GX to OCH)
Mean Gain (dB)
66 50 66 50
Gain Range (dB) 30 30 30 30
Maximum Pin (dBm)
at AGC Threshold -20 (at OCH) -54 -20 (at OCH) -54
Maximum Intermod Distortion (dBm) -13 -13
NF (dB) at Maximum Gain 5 5
VSWR 1.5:1 1.5:1
Gain Flatness/Ripple (dB)
+/- 2.0