User's Manual
Table Of Contents
- 1 1Introduction
- 2 2Installation Guidelines
- 3 3System Installation
- 3.1 Selecting GX Dual-Band Mounting Location
- 3.2 Unpacking and Inspection
- 3.3 Additional Required Tools
- 3.4 Required Headend Connections for Deployments with Corning® Optical Network Evolution (ONE™) Solution
- 3.5 Outdoor Concrete Wall-Mountable Installation
- 3.6 Additional Installation Options
- 3.7 GX Connections
- 3.8 Verifying Normal Operation
- 4 4Appendices
Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 34
3.7.6 System Alarm Pin-Out Description
The GX dual-band system alarm pin-out connector supports
three relay alarm connections. GX dual-band status alarms can
be relayed via a network or modem connection.
Pin Number Description
1 EXT_OPEN
2 EXT_COM
3 EXT_CLOSE
x
System Alarm Pin-Out Description | Table 3.8
3.8 Verifying Normal Operation
Upon powering up the GX dual-band remote unit:
•
Confirm the fans are working after powering.
•
Refer to GX status LEDs (described in Section
1.4, Table 1.2)
and verify normal operation.
GX Dual-Band Status LEDs | Figure 3.28