User's Manual

Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 28
2. Select the appropriate location for the bracket according to
the following criteria:
• General surroundings
• Make sure that the bracket is installed high enough to ensure
convenient access to the GX connectors located on the
underside of the unit when mounted.
• Ventilated and easy-to-reach area
• Proximity to the antenna in order to minimize cable loss
3. Referring to Figure 3.13, mount the wooden pole bracket
according to the following steps:
• Drill four holes in the pole according to the distances shown
in Figure 20.
• Position the bracket onto the wooden pole and screw in the
5/8-in screws (provided) into the top and bottom mounting
holes.
• Screw in the two additional screws into the remaining middle
mounting holes and tighten.
Note: The distance between the bracket bottom screw and the
ground must be at least 20 mm.
Mounting the Bracket | Figure 3.13
4. Mount the GX unit onto the bracket: - referring to
Figure 3.14, hang the GX on the pins protruding from the
relevant top and center parts (depending on single or dual
installation) of the bracket.
Hooking GX onto Bracket | Figure 3.14
Note: For single GX unit installation – unit is mounted onto middle
of bracket (Figure 3.15); For Dual GX unit installations – units are
mounted on the sides of the bracket (Figure 3.16).