User's Manual

Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 23
3.5 Outdoor Concrete
Wall-Mountable Installation
Note: The instructions provided in this section are for solid brick and
concrete walls only.
1. Using the mounting bracket top and bottom mounting
holes as a guide (see Figure 3.5), measure and mark the
location for drilling the (supplied) M10 masonry bolts
(12 mm dia) in the wall (six per bracket).
2. Drill holes for the masonry bolts (using an electric drill with
a 12 mm diameter head).
3. Using six M10x110 masonry bolts per bracket – secure the
mounting brackets to the wall with the protruding
M8 nuts facing toward you
. See Figure 3.5.
GX Bracket Wall-Mountable Option | Figure 3.5
3.6 Additional Installation Options
Additional mounting options are provided with separately
ordered accessory kits:
• Indoor wall-mountable installation (section 3.6.1)
• Wooden pole-mountable installation (section 3.6.2)
3.6.1 Indoor Wall-Mountable Installation
This section provides instructions on how to mount the GX
quad-band unit on indoor concrete walls using the
AK-GX-QUAD-BRKT-INDOOR accessory kit (ordered separately).
Note the following:
• The GX indoor bracket accessory kit is designed for
installations on concrete walls only.
• The GX unit is mounted with the connectors facing
UPWARDS (as opposed to all other installation types).
• Weight: GX (per unit) = 147 lb (66 kg); Bracket = 28.7 lb (13 kg)
The accessory kit includes the following items:
Item Quantity
Top Wall Rack
(6 holes)
1
Bottom Wall Rack
(8 holes)
1
Mounting Ground
Support
1
Sideboard
2
M6×16 Hex Socket
Head Cap screws –
required for sideboard
assembly
8
Spring Washer
8
Plain Washer
8
Kit Items for GX Indoor Bracket | Table 3.4
Additional required tools
• Electric screwdriver with hex bits
• Electric drill with a 12 mm diameter head
• Spanner (0.31-in for tightening GX M8 nuts)
To mount GX in Indoor Installation
1. Determine the installation location so that there is enough
free space for proper ventilation and maintenance access.
2. Referring to Figure 3.6, dismantle the mat and mounting
hooks from the GX by unscrewing the corresponding
M5x12 screws. Save those screws for the following step.