User's Manual

Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 19
3
3
SYSTEM INSTALLATION
This chapter describes the installation procedure for the GX
dual-band remote unit.
3.1 Selecting GX Dual-Band
Mounting Location
Select the mounting location (wall/pole):
• General surroundings
• Ventilated and easy-to-reach area
• Proximity to the antenna in order to minimize cable loss
For installations with GX external multiplexer — take into
consideration that the unit must be mounted adjacent to the
GX RF interfaces to facilitate the connections (DIN-DIN cables =
1.2 m).
3.2 Unpacking and Inspection
Unpack and inspect the cartons as follows:
1. Open the shipping carton and carefully unpack each unit
from the protective packing material.
2. Please verify that the items listed in Table 3.1 are included
in your package (image size is not proportional) and check
for signs of external damage. If there is any damage, call
your Corning service representative.
Item Quantity
GX Dual-Band Remote Unit
1
Mounting Bracket (used for both pole and wall
installations)
1
M8 Nuts, Spring Washers 8 mm diameter, Plain Washers
8 mm diameter – used for securing remote unit when
hung on bracket protrusions
2
(per item)
Masonry Bolt (set) M10x110 – used for wall-mountable
installations
6
Power Supply Cable (AC) – for AC models 1
Power Cable Tube Gasket (DC) – for DC models 2
GX Dual-Band Package Items | Table 3.1