User's Manual

Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 14
Table 1.1 and Table 2.2 provide descriptions of the GX dual-band interfaces and LEDs.
Interface Description
Service Connectors Duplexed RF DIN female output connector to antennas (or external combiner);
Both 2.3 GHz (WCS) and 2.5 GHz service bands are distributed through a single
antenna output port
One connector for SISO models
Two connectors for MIMO models
OP Corning OptiTap® fiber optic waterproof connector – connects to OCH using
Corning OptiTap to SC APC cable (ordered separately). One connector for SISO
models and two for MIMO.
IMPORTANT!
OptiTap pull-out force ranges from a few lbs to 50+ lbs with the
dust cap or connector installed. This prevents damages caused to the DAS unit.
Power Connector (side panel) Power feed option is model dependent (AC/DC). Refer to Appendix A for detailed
power specifications
Note: AC models include power cable. Only provided power cable is to be used for power
connection.
Grounding Lugs Two grounding screws — accessed from side panel; double lugs with 6 gauge
wire
LAN RJ45 connector for local connection (i.e., debugging, troubleshooting)
EXT_ALM External Alarm pin-out connectors supporting four external alarm connections
SYS_ALM Pin-out connector supporting up to three relay alarms used for connecting the GX
dual-band to a network or modem and relaying the status of the GX alarms
WCS SISO CPL -50 dB Coupler port WCS SISO 50 dB coupling
TD25 SISO CPL -50 dB Coupler port 2.5 GHz TDD SISO 50 dB coupling
WCS MIMO CPL -50 dB
(for MIMO model)
Coupler port WCS MIMO 50 dB coupling
TD25 MIMO CPL -50 dB
(for MIMO model)
Coupler port 2.5 GHz TDD MIMO 50 dB coupling
GX Dual-Band Interface Descriptions | Table 1.1