User's Manual
Table Of Contents
- 1 1Introduction
- 2 2Installation Guidelines
- 3 3System Installation
- 3.1 Selecting GX Dual-Band Mounting Location
- 3.2 Unpacking and Inspection
- 3.3 Additional Required Tools
- 3.4 Required Headend Connections for Deployments with Corning® Optical Network Evolution (ONE™) Solution
- 3.5 Outdoor Concrete Wall-Mountable Installation
- 3.6 Additional Installation Options
- 3.7 GX Connections
- 3.8 Verifying Normal Operation
- 4 4Appendices
Corning Optical Communications User Manual
|
CMA-601-AEN
|
Page 13
Example of GX Dual-Band HCM Device Configuration Tab | Figure 1.6
1.4 GX Dual-Band Interfaces
All of the GX interfaces (except for the power connector) are
located externally on the underside of the unit (facing down
when unit is mounted). The unit interfaces include the RF,
ground, optical link, and external alarms connections. The
power connector (AC/DC) is located on the side panel. See
Figure 1.7.
Example of GX Dual-Band Remote Interfaces | Figure 1.7