User's Manual

Device Configuration
P/N 709C011801
Page 97
7.3 OIU Configuration
The OIU configuration consists of defining parameters for the ACM (Auxiliary Controller Module) through which the unit is
controlled and managed and for each installed OIM (Optical Interface Module). Each module is configured through dedicated
configuration options tabs.
7.3.1 OIU ACM
NOTE: The ACM Module Info and Power Alarms are the same for modules installed in either HEU or OIU chassis.
To access the (HEU) ACM, click on the ACM hosted by the HEU in the Network Topology or in the device view area. The ACM
Config pane appears and includes the ACM Alarms (detailed description in HEU (ACM) Alarms section), Power Alarms (detailed
description in ACM Power Alarms section) and Module Info tabs.
Figure 7-6. (OIU) ACM Config Screen
The (OIU) ACM Module Info tab provides the following:
• Module Name (R/W) - click Modify button, enter name and click OK. Name will appear in corresponding field and adjacent
to the device element in the Network Topology Tree.
• General Info (Read-Only) - module information such as Location (defined via Setup Tool - see Zone Information section
for details (on page 78), and S/N, IP address, etc.
• Identify option - when this option is turned On, the corresponding LED on the physical HW (identified as HCM) flickers
rapidly, enabling the physical location to be detected.
• Reset button - enables resetting the module SW by remote