User's Manual

Device Configuration
P/N 709C011801
Page 95
7.2.2 RIM
Each RIM must be configured individually through its' dedicated Config tabs.
To configure RIM
1. Click on the RIM in the Network Topology or in the device view area. The Module Info tab is displayed by default. The
selected RIM (and associated OIM) will appear green in the Device View area.
Figure 7-4. RIM Module Info Tab
The Module Info tab includes general information (R/O) such as Location (defined during Setup procedure), S/N, Band,
Carrier, etc.
2. (Optional) Assign RIM name (if not already assigned):
• Click (Name) Modify button
• Enter indicative name in field
• Click OK
• Assigned name will appear in the Name filed and in the topology tree
NOTE: The Module Info tab includes a Reset button (module SW reset) and Identify function which when turned to On causes
corresponding LED on physical module to flicker rapidly enabling to detect the physical location.
3. Click on the RF Parameters tab. The following tab appears.