User's Manual

Commissioning the System
P/N 709C011801
Page 63
6.4 Running the Setup Procedure
To perform the setup procedure
NOTE: Make sure that you have performed the required pre-setup procedures (see section Required Pre-Setup Procedures)
before running the Setup tool.
1. Click on the main menu Set-up tab.
Figure 6-12. Setup Tab in Main Menu
The Module Owner screen appears (first phase) and the HEU is displayed in the device view area. The unconfigured and
un-assigned RIM modules appear gray.
NOTE: The RIM information can be viewed by placing the pointer on the RIM icon device.
Figure 6-13. Module Owner Screen – Before Group Assignment
2. Click on the RIMs to be assigned to a group (appear green upon selection), select the group to which the RIMs are to
be assigned and then click Submit.
• Repeat for all RIMs until are modules are assigned to a group.