Manualshelf

User's Manual

ManualsBrandsCorning Optical Communication Wireless ManualsElectronicsREMOTE EXTENDER UNIT
51525354555657585960
Commissioning the System
P/N 709C011801
Page 59
To Define… Do This…
Static IP Address
Set DHCP as None.
Enter the IP Address and Subnet.
Click OK.
DHCP Server
Set DHCP as Server and click OK.
WARNING!!! If LOCAL port is set as DHCP Server, DO NOT
connect a network device, as its DHCP server can disrupt LAN
IP addressing. Only use this setting if using the port for direct
connection to a client device (i.e. PC).
Table 6-2. Local Port IP Settings
6.2.1 Default Network Parameters
The following table describes the default settings for each of the Network Ethernet ports located on the Headend Control Module
(HCM).
Port Name Configuration
LOCAL
DHCP: off
IP: 193.168.1.1
Subnet Mask: 255.255.0.0
LAN
DHCP: Client, or Static IP (default)
IP: 192.168.1.1
Subnet Mask: 255.255.0.0
INTERNAL
DHCP: server on (this local port is set by default set to act as a
DHCP Server and provide an IP address to the connected
computer so no configuration of the computer is required)
IP: 11.0.0.1
Subnet Mask: 255.0.0.0
Table 6-3. Default network parameters
D