User's Manual

Unit Descriptions - RF Path
P/N 709C011801
Page 36
2.1.2.2 OIM (Optical Interface Module)
The OIM is a wideband RF to F/O (and vice-versa) media conversion module. Up to 12 OIM units can be installed in each OIU,
where each OIM can support up to three Remote Antenna Unit (RAU) connections.
Figure 2-9. Optical Interface Module
Port
Description
Optical Link MTP Connector for optical interface connection; SMF
Expansion
[6] Kenpole connector for 1:1 direct signal transportation, 3 UL and 3 for DL
Enables (DL and UL) broad band connection to each optical link
Table 2-9. OIM Ports Description
LED Description
Link 1-3
ON - the optical link to/from the connected remote functions within the
specifications in both directions.
Blinking - optical power from remote is lower than required
RUN Steady Green – SW Boot up sequence complete and functioning
PWR Steady Green – Power input detected for corresponding module
Table 2-10. OIM LED Descriptions