User's Manual

Introduction
P/N 709C011801
Page 23
1.6.1 Overall Device Display - Configuration Tab
The Config window is displayed by default upon login and includes the following for each selected element:
• Network Topology Tree - hierarchically displays the connected and available site devices and their status.
• Device Configuration Tabs - device specific which include the configurable parameters (e.g. service control, RF parameters)
and general information (e.g. device name, Firmware version)
• Device View - visualization of device, with LEDs corresponding to the device status. Device view can be used for fault
sourcing at a glance.
• Alarms - displays the device alarms for fault sourcing and provides alarm masking options
Note the following:
• The device selected in the Network Topology Tree appears green in the Device View Mode area
• Point to module in Device View to display property info
Figure 1-7. Config Tab
1.6.2 Session Access
• Number of simultaneous sessions - the HCM supports up to three simultaneous sessions for multiple users (local/remote
access).
• Login Priorities - the login of users is enabled according to priority – when the maximum amount of multiple users are logged
in, the HEU terminates the session running for the lowest level user logged in the longest (user receives alert message and
force logout is performed) in order to enable a higher access level user to login to the system. A message indicating logon
denial appears when the maximum number of users is logged in and a lower level user attempts to log in to the system.