User's Manual

Monitoring and Troubleshooting
P/N 709C011801
Page 127
Alarm Name
Description
HW Failure Indicates HCM faulty HW
Adjustment Failure Indicates unsuccessful adjustment procedure
Installation Failure Indicates faulty physical installation in one of the modules
SW Release Mismatch
Indicates that a module (or modules) in the system does not have the
defined active release; several modules may not have corresponding
SW versions; severity – minor
Connectivity
Indicates faulty connectivity state in one of the in one of the previously
discovered (baseline) system modules. Module should appear grey in
the Network Topology and the Device View Mode.
Table 9-3. HCM Alarms Descriptions
9.3.2 ACM Device Alarms and View
The device alarms and view for the ACM module are similar for both HEU and OIU chassis. The ACM Device view and Alarms are
viewed by clicking on the ACM item (under the host HEU or OIU) in the Network Topology. The ACM monitors the PSM alarms,
where the alarms for each PSM can be viewed via the Power Alarms tab.
Figure 9-5. (HEU) ACM Device View and Alarms
Figure 9-6. ACM Device View and Overall Status LED