User's Manual

Administration
P/N 709C011801
Page 121
8.6 Firmware Upgrade
The HCM firmware can be upgraded via the web-based GUI. Upgrading the SW requires loading the SW to the Standby Bank,
and swapping the Standby Bank with the Active Bank.
To perform SW upgrade on an HCM installed in the master HEU
1. Open session to HCM (see Opening a Local Session). Click the Management tab and then the Firmware menu option. The
following screen appears.
Figure 8-20. Firmware Upgrade Procedure
2. If necessary, download Bootloader for upgrade procedure as follows:
• In the Load New Firmware area, click the Browse button and select the SW upgrade Bootloader file: boo HCM vX.btl
• Click the Load button (appears after file is selected) to load the selected upgrade file on to the HCM.
• Download progress appears in Progress bar. Click OK when “Download is Complete message” appears (see following
figure).
3. Download the new SW for upgrade procedure as follows:
• In the Load new Firmware area, click the browse button and select SW upgrade img file: HCM VerX.img
• Click the Load button
• Download progress appears in Progress bar. Click OK when Download is Complete message appears
4. After the SW download (in previous step) is complete, perform SW upgrade on the HCM as follows: