User's Manual

Table Of Contents
CMA-331-AEN Page 167
Draft
3. Pull down the Dumper to a vertical position.
Figure 10-4. Lowered Dumper Arm
10.3.3 Mounting RAU5
1. Fit the four Pins on the RAU5 Underside into Wide End of Corresponding Dumper Keyholes and Pull down into Narrow Ends
to Secure.
Note: Dumper captive screw must face the RAU5 connectors
Figure 10-5.Fitting RAU5 onto Dumper Bracket
2. Close Dumper Captive Screw to Secure RAU5 in Place.
Note: it is recommended to perform the RAU5 connections after the unit is secured to the Dumper.