User's Manual

Table Of Contents
Installation RF Path Elements CMA-331-AEN Page 111
Draft
5.2.1.2 Installing Power Supply Module
Note: The power supply modules are hot-swappable and can be installed/extracted either before or after power-up.
1. With the lever up, slide the power supply module into any of 1-4 PS slots on the ICU chassis rear (Figure Figure 5-56).
Figure 5-56. Inserting Power Supply Module
2. Push in the module until the lever meets the chassis (Figure 5-57).
Figure 5-57. Securing PS Module in ICU Chassis
3. Secure by pulling the lever downward until it “clicks" and module is flush with chassis rear.