User's Manual

Table Of Contents
Corning Optical Communications User Manual I CMA-490-AEN I Page 53
5.1.2 Installing the Power Supply Module
Note the following:
Modules can be inserted either before or after enclosure is mounted.
The power supply modules are hot-swappable and can be installed/extracted either before or after power-up.
To install the power modules
1. With the lever up, slide the power supply module into one of the six slots on the PSU6 enclosure rear (Figure 5-1).
Figure 5-1. Inserting Power Supply Module
2. Push in the module until it is flush with the chassis.
3. Secure by pulling the lever downward until it “clicks" and the module is flush with chassis rear. See Figure 5-2
Figure 5-2. Securing PSM in Slot