User's Manual
Table Of Contents
- Corning
- Mid-Power Remote Unit (MRU)
- Preface Material
- About This Manual
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- Regulatory Compliance Information
- RF Safety
- Laser Safety
- Care of Fiber Optic Connectors
- Company Certification
- Licensee Contact Information
- Table of Contents
- 1 Introduction
- 2 MRU Interfaces
- 3 Installation Guidelines
- 4 Installation
- 5 Appendix A: Specifications
- Supported Services
- Coupling Specifications
- Physical Specifications
- 6 Appendix B: Ordering Information
Installation CMA-438-AEN Page 30
Draft
4.4 Fiber Connections
To connect optic fiber
1. Remove the LC APC connector plugs.
2. Using Corning
®
SMF-28
®
fiber (or compatible), connect the MRU LC APC fiber connector towards the ICU. See
Figure 4-6.
Figure 4-6 Fiber Connections toward ICU
4.5 RF Antenna Connections
Connect the MRU male DIN type 4.3-10 duplexed RF “ANTENNA” port to the broadband antenna(s) using appropriate coax
cables. See Figure 4-7.
The MRU includes one 4.3-10 Type RF port used for connecting to a 2.5 GHz external RF source (e.g. picocell).
Figure 4-7 Example of MRU Connections to Broadband Antennas (Via Splitter)