Instruction manual

TS-009AS Version 05/05 Page 4 of 4
Appliance Operation
It is recommended that the Ice Cream Container is filled with a maximum
volume of 1 litre (1000ml. or 35 fluid ounces) of pre-mixed ingredients. This
volume comes to approximately 4 centimetres (1½ inches) below the top edge
of the Container.
There are three reasons for this. Firstly ‘pre-mixed ingredients’ because some
recipes may be written for different capacity appliances and simply adding a
complete list of ingredients one at a time could overfill the Ice Cream
Container causing it to overflow. Secondly pre-mixing ensures the ingredients
are thoroughly mixed. Finally some ingredients can increase in volume as
they freeze and leaving space for such expansion could avoid an overflow.
Some recipes require small ingredients to be added during the freezing cycle
and for such recipes a Small Ingredients Entry Cover is provided in the right
hand side of the clear Perspex top cover. These ingredients should be added
in accordance with recipe directions where given, or if no directions are given
the softer the ingredient being added the nearer the end of the cycle it should
be added to avoid it turning to mush. Care should be taken not to exceed the
one litre appliance capacity when adding ingredients in this way and that the
ingredients are chopped small enough to enter.
If the recipe being followed would provide in excess of 1 litre of mixed
ingredients then it should either be scaled down or any excess should be
discarded. The storage of pre-mixed ingredients is not recommended.
Remove the appliance Top Assembly and place carefully to one side. Remove
the Ice Cream Container and pour in up to 1 litre of pre-mixed ingredients, this
will fill the Container to approximately 4 cm. from its top rim.
Replace the Ice Cream Container into the Refrigeration Barrel ensuring that it
is fully inserted. The Ice Cream Container is a tight fit into the Refrigeration
Barrel and it may be necessary to push down evenly on the Container rim to
ensure it is fully inserted. It is important to replace the Ice Cream Container in
the correct orientation. The two lugs on the Ice Cream Container top rim to
which the wire handle is fixed must align with the two cut-outs in the clear
rubber seal around the edge of the Refrigeration Barrel. The wire handle
must also be folded towards the front of the appliance. (The two cut-outs in
the seal are at approximately ’ten minutes past the hour’ and ‘twenty minutes
to the hour’ when viewed from the front of the appliance.) If correct
orientation and handle position are not maintained electrical connection to the
paddle motor may not be made and the paddle might not turn.
Replace the Top Assembly ensuring it is pushed down and squarely seated,
and plug the appliance into a suitable electricity supply. Switch on the Mains
On/Off switch on the lower right rear of the appliance.