CORNELIUS INC www.cornelius.com ICE/BEVERAGE DISPENSER MODEL: TRIAD–150 Operator’s Manual Release Date: May 01, 1998 Publication Number: 620911101 Revision Date: May 07, 2014 Revision: D THIS DOCUMENT CONTAINS IMPORTANT INFORMATION This Manual must be read and understood before installing or operating this equipment © CORNELIUS INC; 1998-2014 PRINTED IN U.S.
TABLE OF CONTENTS Page MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 DAILY (OR AS REQUIRED) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 WEEKLY (OR AS REQUIRED) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 MONTHLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MAINTENANCE The following dispenser maintenance should be performed at the intervals indicated: DAILY (or as required) Remove foreign material from vending area drip tray to prevent drain blockage. WEEKLY (or as required) Clean vending area. Check for proper water drainage from the vending area drip tray. MONTHLY Clean and sanitize the hopper interior and beverage system, if applicable (see CLEANING INSTRUCTIONS). START-UP & OPERATING INSTRUCTIONS Fill the hopper with ice.
DISPENSER 1. CLEANING EXTERIOR SURFACES Important: Perform the following daily. A. Remove the cup rest from drip tray. B. Wash the drip tray with soap solution. Rinse with clean water and allow solution to run down the drain. C. Wash cup rest with soap solution and rinse in clean water. Install the cup rest into the drip tray. D. Clean all exterior surfaces with soap solution and rinse in clean water. 2. COLD PLATE INSPECTION BEFORE CLEANING A. Remove splash panel. B.
BEVERAGE SYSTEM (IF APPLICABLE) WARNING: Disconnect Power Before Cleaning! Do not use metal scrapers, sharp objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage may result. Do not use solvents or other cleaning agents, as they may attack the plastic material. Soap solution - Use a mixture of mild detergent and warm (100 F) potable water. Sanitizing solution - Use 1/2 ounce of household bleach in 1 gallon of potable water.
n. B. Discard the tank of sanitizing solution and reconnect the product (syrup or pre-mix) tanks. Operate the valves until all sanitizer has been flushed from the system and only product (syrup or premix) is flowing. Sanitize syrup lines, B-I-B Systems a. Remove all the quick disconnects from all the B-I-B containers. b. Fill a suitable pail or bucket with soap solution. c. Submerge all disconnects (gas and liquid) in the soap solution and then clean them using a nylon bristle brush.
TROUBLESHOOTING IMPORTANT: Only qualified personnel should service internal components or electrical wiring. WARNING: If repairs are to be made to a product system, remove quick disconnects from the applicable product tank, then relieve the system pressure before proceeding. If repairs are to be made to the CO2 system, stop dispensing, shut off the CO2 supply, then relieve the system pressure before proceeding.
Trouble BEVERAGES NOT SWEET ENOUGH. BEVERAGES NOT COLD (UNITS WITH BUILT-IN COLD PLATE). Probable Cause A. Empty syrup tank. B. Faucet brix requires adjusting. A. Unit standing with no ice in hopper – no ice in cold plate cabinet. Contact your local syrup or beverage equipment distributor for additional information and troubleshooting of beverage system.
PARTS LIST / EXPLODED VIEW 7
34 16 38 4 39 22 1 33 26 49 7 24 45 43 23 2 58 28 66 47 32 54 27 50 51 30 54 51 20 59 68 46 21 17 52 54 67 3 5 52 36 64 42 53 54 14 6 52 40 14 18 64 35 25 61 61 63 57 9 72 BEV PANEL PEPSI 44 64 BEV PANEL PEPSI 31 48 8 12 11 10 52 69 29 10 41 13 57 19 37 60 15 FIGURE 1.
CABINET SECTION PARTS LIST Index No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 Part No. 21491 22081 29303R 15346 29483 Contact Sales 620019001 29313 Contact Sales 27107 10145 31007 50099 50767 620034009 15087 30794 32826 Name Gate Slide Gate Restrictor Plate, Motor Mounting Agitator Assy Cover, Rear Wrapper Lower Panel Assy Electrical Box Wrapper Panel C/P Faucet Assy Bracket, Depressor Mtg.
CABINET SECTION PARTS LIST (CONT’D) 51 70456 3/16 Pop Rivet 52 70171 # 8-32 x 3/8 Phil. Truss 53 70178 # 8-32 x 1/2 Phil. Truss 54 70204 # 8 x 1/2 A S.S. Phil. Truss 55 71089 Shoulder Screw 56 70250 1/4-20 Truss HD Phil Screw SS 57 15501 15500 Push Lever, Ice Dispense Lever Ass’y (Cup Activated) 58 70260 1/4-20 x 1 Phil RD HD S.S. Screw 59 70341 Gate Slide/Motor Heater Spring 60 70478R 61 70555 # 8-32 x 2-5/8 Phil.
18 17 16 22 15 3 19 2 10 22 8 5 22 13 4 11 19 7 6 9 11 19 22 1 FIGURE 2. ELECTRICAL BOX ASSEMBLY EXPLODED VIEW ELECTRICAL BOX ASSEMBLY Item No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Part No.
SOLENOID ASSEMBLY 13 1 4 10 3 7 14 4 12 9 11 6 8 2 5 FIGURE 3. SOLENOID ASSEMBLY Item No. Part No. Name 32954 Gate Solenoid Ass’y, 120 Volt 33397 Gate Solenoid Ass’y, 240 Volt 1 28172 Plate, Solenoid Mounting 2 28173 Arm, Gate Lift 3 32957 Solenoid 4 50752 Isolator 5 50754 Bearing, Gate Arm 6 70162 Screw, No. 8-32 By 1/4-In. Long 7 70015 Hex Nut, No. 10-32 8 51689 Locktite 9 70165 Screw, No. 8-32 By 5/8-In. Long 10 70057 Lockwasher, No.
DRAIN 1 1 3 4 2 1 1 3 5 FIGURE 4. DRAIN FOR Z STYLE UNITS Item No. Part No.
CORNELIUS INC. www.cornelius.
