Operator`s manual

906143
OPERATOR INSTRUCTION
OPERATING INSTRUCTIONS
Fill the hopper with ice and replace the lid. Pushing the dispense lever will cause ice to flow from the ice chute.
Ice flow will continue until the lever is released. If ice does not dispense, see the “Troubleshooting Guide” to find
the cause
CAUTION: Use caution to avoid spilling ice when filling dispenser. immediately Clean up
any spilled ice from filling or operation of the unit. To prevent contamination of ice, the lid
must be installed on the unit at all times.
CLEANING INSTRUCTIONS
WARNING: Disconnect power before cleaning. Do not use metal scrapers, sharp objects,
or abrasives on the surface of the liner as damage may result. Do not use solvents or other
cleaning agents, as they may attack the plastic liner.
Dispenser
1. Clean the ice dispenser interior at lease once a month.
2. Remove agitator assembly, wash and rinse it thoroughly.
3. Wash down the inside of hopper and top cover with mild detergent solution. Rinse thoroughly to remove all
traces of detergent.
4. Replace agitator.
5. Sanitize the inside of hopper and agitator with a solution of 1 ounce household bleach in 2 gallons of
water. (200 PPM)
6. Remove Ice chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift Ice Chute cover to disengage upper pins.
C. Lower Ice Chute cover down out of unit. Note: It may be helpful to twist cover slightly.
7. Clean the inside of the ice chute and ice chute cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
8. Reverse steps above to reassemble ice chute.
9. Sanitize as described in step 5.