Operator`s manual

3 90683
INSTALLATION INSTRUCTIONS
1. The ice dispenser must be sealed to the counter The template drawing (Figure 6) indicate openings which
must be cut in the counter. Locate the desired position for the dispenser, then mark the outline dimensions
on the counter using the template drawings. Cut openings in counter.
Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equal) approximate-
ly 1/4 inside of the unit outline dimensions and around all openings. Then position the unit on the counter
within the outline dimensions. All excess sealant must be wiped away immediately. A models must be
fastened in place with mounting hardware provided.
2. A and K Models Only: Install the ice maker according to the instructions supplied with the kit, and
manufacturers instructions supplied with the ice maker.
3. Connect the drain tube to an open drain. If additional piping is required, it must be 3/4 IPS (or equal). This
line must continually pitch downward away from the unit and must contain no traps, or improper drainage
will result.
4. Clean the ice dispenser interior (see CLEANING INSTRUCTIONS).
5. Connect the power cord to a 115 volt, 60 cycle, 3-wire grounded receptacle. A models must be perma-
nently wired and conform to NEC and local codes.