Technical information

Non-Carbonated Impulse Installation & Operational Manual

INSTALLATION PROCEDURE

COUNTER-TOP INSTALLATION

NOTE: Optional 4-inch legs (p/n 3184) will elevate the unit 4 inches above counter (order 4 legs).

1. Place the unit on a level counter capable of supporting at least 400 pounds.

2. Remove drip tray and front access panel.

3. Turn power switch off then remove screw located next to the power switch and the screw at top of front panel.

Next, remove front panel, disconnect wires to valve key lock switch, and peal back magnetic decals from the

top. Lift off top center section.

4. Pull water, concentrate, and CO

lines through counter or wall. To comply with NSF International requirements

the unit must be sealed to the counter top and all access holes in the unit base must be sealed, or the unit can

be installed using the optional 4-inch legs (P/N 3184). Caulk/seal the unit to the counter using Dow Corning

RTV 731 or equivalent approved sealant.

5. Pull plastic “wire tie” to remove hitch pin from condenser fan motor assembly (this pin is only needed during

shipping).

Figure 1.

6. Fill the water bath with clean water until it comes out the overflow tube. Make sure the overflow tube is not

blocked or plugged. Use low-mineral tap water, not distilled or deionized water.

Figure 2.

NOTE: Water bath must be filled with water before the unit will run.