Technical information

Non-Carbonated Impulse Installation & Operations Manual

INSTALLATION

WARNING:

It is the responsibility of the installer to ensure that the water supply to the dispensing equipment is provided with

protection back flow by an air gap as defined in ANSI A 112.1.2-1979; or an approved vacuum breaker or other such

method as proved effective by test and must comply with all federal, state and local codes.

Failure to comply could result in serious injury, death or damage to the equipment.

Water pipe connections and fixtures directly connected to a potable water supply shall be sized, installed and

maintained according to Federal, State and Local laws.

INSTALLATION REQUIREMENTS

Requirements Summary

18-Inches above 6-Inches on Sides and Rear

ELECTRICAL REQUIREMENTS

Before connecting electrical power to the unit refer to nameplate to verify power requirements

DANGER:

To avoid possible serious injury or death the ELCB (earth leakage circuit breaker) must be installed in electrical cir-

cuit of all 50 Hz units.

WARNING:

To avoid possible electrical shock the unit must be electrically grounded using the green grounding screw provided

inside the electrical contractor box.

CAUTION:

The wiring must be properly grounded and connected through a 10-amp disconnect switch (slow–blow fuse or

equivalent HVAC/R circuit breaker). ALL WIRING MUST CONFORM TO NATIONAL AND LOCAL CODES. MAKE

SURE UNIT IS PROPERLY GROUNDED

Weight

Front or rear counter must be level and able to support 400 lbs

Environment

Indoor Installation only

Temperature

40° To 110° F Ambient Temperature

Clearance

CO2:

75 Psi (5.25 Bar) At Unit With Internal Carbonator

Concentrate:

60 Psi

Water

50 Psi Maximum

Electrical:

See Nameplate On Unit For Electrical Requirements