Technical information

Ice Frost Training Manual

12. Unscrew the fastening knob (A) clockwise

as the direction indicated by the arrow

(threading to the left) and extract the spiral

scraper (C) and the seals (B) and (D).

Clean the individual parts thoroughly

(FIGURE 27).

FIGURE 27

13. Clean the drip tray (A) and the evaporator

(B) (FIGURE 28).

14. Replace the mixing unit as follows:

• Dampen the sealing strip (FIGURE 27,

D) and insert it into its seating.

• Apply a generous amount of food grade

lubricant (supplied with the machine) to

the suction cup seal (FIGURE 27, B) (on

the part that comes into contact with the

evaporator FIGURE 28, B) and insert it

in its spiral seating.

• Replace the spiral scraper (FIGURE 27,

C).

• Fasten all the components in place by

screwing the knob (FIGURE 27, A)

counter-clockwise.

FIGURE 28

15. Replace the bowl by pushing it into its seating.

16. Fasten the bowl in place by tightening the knobs (FIGURE 23) and the locking bar (FIGURE 21).

17. Replace the tap, remembering to smear both is seating in the bowl and the seals with food grade

lubricant

18. Remove the drip tray (L1) by rotating it

slightly and pulling it outwards (FIGURE

29).

Wash all the parts carefully and

reassemble it by following the prior

operations, remembering to re-insert the

condensation discharge pipe (M1) in its

seating.

FIGURE 29