Technical information

Ice Frost Training Manual

Viewing the Bowl Temperature

1. Turn ON the auger on the side that you want to display the bowl temperature (press the “AGER ON/

OFF” button).

2. Press the “PRESS TO SELECT FUNCTION” button until the “Cold” LED is lit. The display will now

show the current bowl temperature in either

F or

C as applicable.

DISPENSING PRODUCT

1. To dispense the product, place the cup beneath the

dispensing valve and pull the lever very gently (FIGURE

15).

FIGURE 15

CONSISTENCY ADJUSTMENT

2. Adjusting the viscosity (consistency):

To vary the viscosity of the product, turn the knob as

shown in FIGURE 16.

Turning the knob counter-clockwise will increase viscosity

(make the product denser).

Turning the knob clockwise will decrease viscosity (make the

product less dense).

ATTENTION: This control only changes the viscosity of the

product dispensed, it does not effect the COLD

temperature.

ATTENTION: When the level of the product inside the bowl

is below the minimum level, you must switch the COLD

system to the OFF position, or refill the bowl, following the

instructions given in the previous paragraphs.

An indicator gauge for reference is located on the back of the

unit approximately 6 inches below the adjustment knob.

NOTE: This indicator can not be viewed on all models.

NOTE: Do not turn knob after you reach the upper or lower

limits. Doing so can damage the assembly.

FIGURE 16