Technical information

Ice Frost Training Manual

BOWL LOADING OPERATIONS

ICE FROST GENERIC (PRE-MIX)

WARRNING: If the unit runs out of product and is turned off and turned back on without a

new (full) product tank installed the sensor will look for product for 4 minutes. During this 4

minute period CO

will be purged from the bowl.

ICE FROST GENERIC (POST-MIX)

• Switch the machine’s main switch to the ON position (1).

• Put the switch (A) into the ON position (1) see FIGURE 11,

switch A. Controls the flow of the product in the bowls.

• The machine’s bowls will now fill up until the maximum level

is reached.

• Continue with start up operations.

FIGURE 11

• Switch the machine’s main switch to the ON position (1).

• Make sure the switch FIGURE 11, Item A is in the OFF

position (0) - (the switch controls the flow of the products in

the bowls).

• Turn mixing motors OFF immediately. Do not run units with

bowls empty.

• Using an 1/8 inch (8 mm) socket wrench, loosen the nut that

holds the post-mix valve.

• Twist nozzle counter-clockwise, lift the post-mix valve up

slightly and turn it towards the outside, leaving nozzle and

coupling attached to the bowl.

FIGURE 12