Instruction manual

7 - REFILLING OPERATIONS

Fig. 6

- Lift the cover (G) by pushing it upwards from the front

until it reaches the stopping position.

- Lift the lever (H) as shown in the figure to vent the airtight

tank and to allow the cap (I) to be removed (see fig. 6).

- Remove the cap (I) by rotating it anticlockwise and pulling

it upwards, as shown in figure 7.

-Pour the fizzy drink into the tank until it reaches the

maximum level (8 litres). Each tank has a MINIMUM and

a MAXIMUM level mark (see fig. 8).

Fig. 7

Fig. 8

Note

To prevent the gas in the drink being released and lost

outside the tank, you are advised to insert the neck of the

bottle, or a similar container, directly into the tank, as shown

in the figure. You should also try to complete the operation

as quickly as possible.

- Close the cap (I) immediately and lower the lever (H) to

create an airtight seal and to ensure the interior of the

tank is pressurised and aseptic.

-Lower the cover (G), moving the lever (J) to the left as

shown in the figure.

- Make sure the pin (K) of the cover is inserted into its socket

so that the apparatus can be switched on immediately

with the switch (L) (fig. 9).

Fig. 9