Instruction manual

j) Loosen the fastening knob (F1) by turning it in the

direction indicated by the arrow (left-hand screw thread)

and proceed to extract the scraping spiral (G1) and the

washers (H1) and (I1).

Clean all the individual parts carefully (fig. 35).

k) Clean the drip surface (J1) and the evaporator (K1)

properly (fig. 36).

l) To re-assemble the mixer unit, proceeding as follows (fig.

37):

- dampen the sealing strip (I1) and insert it in its seating;

-grease the suction strip seal (H1) well using the Vase-

line supplied in the tool kit;

- remount the scraping spiral (G1), making sure its head

is perfectly aligned with the guide shaft;

-fasten all the components by turning the knob (F1)

anticlockwise.

m) Remount the tank by pushing it into its seating and

making sure it is perfectly sealed with the strip (I1) (fig.

38).

To facilitate this operation, you are advised to grease

the rear part of the tank with Vaseline at the point in

which it comes into contact with the sealing strip (I1).

Proceed to fasten the tank by tightening the knobs (A1),

the locking bar (Z) and the safety key (Y).

Fig. 35

Fig. 36

Fig. 37

Fig. 38