Instruction manual

Both functions have now been programmed to start

automatically.

When the red LED next to the

button (O) lights up,

this means the functions are running in the automatic mode.

To switch from automatic to manual mode, press again the

button (O) (the relevant red LED will go out, thus

confirming that the machine is set to be operated manually).

8.3 - Variations in the time display (twenty-four or twelve

hour clock) and the temperature display (°C or °F)

The electronic system in the Ice Frost Manual 2.2 is set

during the production phase to indicate the time in the

twenty-four hour clock and the temperature in degrees

Celsius.

However, there is an electronic key which can be used to

vary these values and express the time in the twelve hour

clock and the temperature in degrees Fahrenheit.

To do so, proceed as follows.

Starting with the machine switched off, hold down the

button (N) and at the same time, switch on the machine

using the main switch “M”.

The number “24” will flash on the display. If the user presses

the

(O) button, the display will switch to “12”. At this

point, the variation must be confirmed by the MODE button

being pressed.

Then the symbol “C” (degrees Celsius) will start to flash on

the display. When

(O) is pressed, the symbol “F”

(degrees Fahrenheit) will appear and this must be confirmed

by pressing the MODE button.

Fig. 10